What's an easy way to fasten/unfasten to bind two horizontal poles?
I need a knot that can be fastened and unfastened as quickly as possible (like a toggle on a jacket; twist and release). I also need to be able to tighten or loosen the rope easily. Basically, I want a rope that works how a seatbelt works.
I can only envision a loop at one end and a "stopper" at the other end, like one, might find in a bracelet. Here's an example of what I mean.
Then I would need to be able to tighten this loop.
My goal is to bring two horizontal poles close together by looping a rope around them.
This seems like such a simple concept and yet my searches have proved fruitless, likely because I don't even know where to begin with knot fundamentals (from my Scouts days I have retained nothing more than the reef knot!).
There's one more old scout knot that applies in this case, the pole hitch. A bit of an obscure one as it's very limited …
5y ago
How about repurposing an old belt. Add a few more holes to it.
5y ago
If you can live with steps in the adjustments you can make a loop like the bracelet but with a series of balls or loops. …
5y ago
Charles answer is the correct one for speed. The traditional answer is a sheer lashing. 3 loose turns around the pair …
5y ago
If speed is the goal here, then just use a nylon belt with a buckle. To shorten just cut one end and then seal it with a …
5y ago
This post was sourced from https://outdoors.stackexchange.com/q/22384. It is licensed under CC BY-SA 4.0.
5 answers
There's one more old scout knot that applies in this case, the pole hitch.
A bit of an obscure one as it's very limited in application, the sole purpose of this hitch is to gather horizontal poles together.
Make a large 'S' in the rope under the poles such that you have an end and a loop on each side, put each end round the poles and through the opposing loop, bring the ends back together over the poles and secure the ends together with your choice of knot.
This post was sourced from https://outdoors.stackexchange.com/a/22386. It is licensed under CC BY-SA 4.0.
0 comment threads
Charles answer is the correct one for speed.
The traditional answer is a sheer lashing. 3 loose turns around the pair (or trio) of poles, then pass between the poles twice, pull tight and tie off. I wouldn't want to hold my breath while undoing this on a dark rainy night.
The image above has more turns around the poles than I would normally use.
This post was sourced from https://outdoors.stackexchange.com/a/22456. It is licensed under CC BY-SA 4.0.
0 comment threads
If you can live with steps in the adjustments you can make a loop like the bracelet but with a series of balls or loops.
Or you can put a moving knot to tighten the loop. This will not have steps but you may need to adjust before you apply.
You can see samples of both on this page, (my own not commercial website.) The series of ball knots and the closure knot which will allow adjustment for the length. You will still need to arrange them into the shape that works for you.
This post was sourced from https://outdoors.stackexchange.com/a/22461. It is licensed under CC BY-SA 4.0.
0 comment threads
How about repurposing an old belt. Add a few more holes to it.
This post was sourced from https://outdoors.stackexchange.com/a/22467. It is licensed under CC BY-SA 4.0.
0 comment threads
If speed is the goal here, then just use a nylon belt with a buckle. To shorten just cut one end and then seal it with a lighter.
Easy on and off and if you need more security wrap it twice before buckling.
0 comment threads
0 comment threads