Stopper with Toggle for Blake's Hitch
I'm a knot novice and I was thinking about using a Blake's hitch while camping. The hitch is finished with a stopper knot, which appears pretty critical to me. I thought it would make sense to insert a small stick into the stopper knot to function like a toggle does on a tarp grommet (I think it's called a toggle). I imagine that something like this might be useful in some other context also.
Are there stopper knots that are particularly suited to holding a toggle/stick? Are some stopper knots a bad idea for this purpose? Finally, is putting a toggle on the end of a Blake's hitch a bad idea for some reason?
P.S. I considered just using a constrictor knot on the toggle instead of a true stopper knot, but I read that this can be impossible to untie after use and that scared me off.
P.P.S. I was thinking of using this like a taut line hitch. Appeared more secure and easily adjustable.
This post was sourced from https://outdoors.stackexchange.com/q/16629. It is licensed under CC BY-SA 3.0.
2 answers
The Blake's hitch is widely used in on-rope tree climbing / arborist work (Doubled Rope Technique, DdRT, methods). The nature of on rope tree climbing lends itself to having many loading/unloading cycles.
Typically when tied and properly adjusted, climbers will put either a simple overhand, double fisherman's, or figure 8 in the tail. Anything more than this isn't deemed necessary for life-saving utilization of this knot, which is more critical than it being used for tarp tie offs.
I'd stick with just a simple overhand knot (as shown in your link) or a figure 8. Just be sure to properly adjust and set the knot before heavily loading it.
This post was sourced from https://outdoors.stackexchange.com/a/16639. It is licensed under CC BY-SA 3.0.
0 comment threads
The stopper knot is purely a backup to prevent disastrous slippage (i.e., the end pulling through the knot). For most cases, the stopper knot will not be loaded. Even in the case of slippage, the stopper knot is only taking a fraction of the weight so will probably not become overly tight.
If your use case is going to likely result in the heavily loading of the stopper knot, you probably want to consider a different tension hitch.
This post was sourced from https://outdoors.stackexchange.com/a/16630. It is licensed under CC BY-SA 3.0.
0 comment threads