Is it ok to use rolled aluminum descending rings in permanent anchors?
Rolled aluminum descending rings like the SMC Descending ring are light (11g) and cheap ($3) which makes them great for carrying and leaving behind on long descents, but in my mind they are disposable pro, you use them once for retrieving your rope after a rappel and then then leave them to rot.
More than once I've seen these rings used with mallions on bolted anchors at high-traffic rappels, but I never use them, some I've replaced with strong 50kN steel rings. They're rated for 14kN, which is more than enough for body weight on a nice controlled rappel, but are they suitable for multiple uses?
What's the rule of thumb for this style of descender ring?
This post was sourced from https://outdoors.stackexchange.com/q/7327. It is licensed under CC BY-SA 3.0.
2 answers
SMC's site doesn't say anything very helpful but, keep in mind that 14kN is enough to lift a medium sized car. In a rappel only situation, it should last for years.
That being said....using 'left gear' is a judgment you should make for yourself. Even if you can't see any defects in a piece of metal, you never know if it has an invisible crack from taking a big fall, freeze-thaw damage (that thing is hollow, right?) or previously being to used pull a car out of a ditch.
For myself, I would want a backup.
This post was sourced from https://outdoors.stackexchange.com/a/7329. It is licensed under CC BY-SA 3.0.
0 comment threads
No
It is not ok to use that type of descending ring for fixed anchors.
SMC Descending Rings are a one-piece aluminum ring which are intended to be placed at the top of a pull down rappel in place of a carabiner in order to facilitate recovery of ropes.
SMC issues the following for care, maintenance and retirement schedule needs of their descender rings:
CARE, MAINTENANCE and RETIREMENT SCHEDULE NEEDS
Always inspect Descending Rings before each use and periodically while in storage. The user, depending upon their specific environment and storage methods, must determine the period between inspections. Inspect for cracks, warping, deep gouges and worn areas, making sure that what may appear to be a scratch is not actually a crack. Look for sharp edges or rough areas that might abrade a rope. After each use, remove all dirt and allow Descending Rings to dry in a warm place before storing. SMC Descending Rings will continue to provide reliable performance only when used safely and properly maintained and stored. It is also suggested that the user maintain a permanent record listing the date and results of every usage inspection.
We recommend the regular inspection of all rescue equipment and strongly suggest retiring gear when ANY of the following applies:
- Regular inspection reveals warping, cracks, deep gouges or any wear.
- It is physically damaged or no longer functions as when new.
- It has been subjected to an abnormally high loads, such as in a fall or exposed to heat sufficient to alter its surface appearance.
- You are not completely satisfied that it meets the needs of its intended use.
- The history of the gear is unknown or otherwise in question.
Source: [PDF] SMC Descending Rings #81600, Seattle Manufacturing Corporation
The history of any SMC descending rings that you may find attached to an anchor is unknown and therefore it is strongly suggested by the manufacturer that you retire those rings.
Do your fellow abseilers a favour and remove those rings from any anchors you may find them attached to. Either destroy them, or mark them as retired and use them to hang your hammock.
Lightweight aluminium descender rings are designed for quick descents of alpine routes, they are not intended to be used for heavy duty applications. The improper use of any piece of equipment is unsafe:
Use the right tool for the right job! Thin alloy rap rings are not intended for heavy-duty use, carefully inspect descender rings and retire if they show any sign of wear.
This post was sourced from https://outdoors.stackexchange.com/a/7330. It is licensed under CC BY-SA 3.0.
0 comment threads