How to make DIY ice axe protectors?

I can think of the following two ways to cover the blade:

1. You can use something like a Bike Handle cover, the one that has a cap on the other end. You can get it of the size that your axe-blade fits in. I assume that the main blade will be a bit hard to fit in, but then you can always give a try towards getting the handle cover which is a bit flexible(probably made of vulcanized rubber?)
2. You could get a leather packet sewed/tailored to fit the blade in. Provide some kind of a sling-thread thing to wrap around it?

posted about 10 years ago

CC BY-SA 3.0

WedaPashi‭

749 reputation 150 137 113 0

I was once shown a great way to protect the blade on a wood axe or hatchet.

I realize that ice axes are a different shape than wood axes, so this may not be a perfect solution, but maybe it will give you an inspiration for something similar.

1. Get an old garden hose.
2. Cut a length of the hose about as long as the axe's blade.
3. Cut an incision down the length of the piece of hose.
4. Force-fit the axe blade into the slice in the hose.

If it's a stiff enough hose, it stays on pretty well, but for travel you may like to tie it on with twine or tape.

For the pointy end of the ice axe, perhaps an old tennis ball can protect it.

posted about 10 years ago

CC BY-SA 3.0

Bill Karwin‭

11 reputation 0 1 1 0

For the spike, I usually just take a piece of corrugated cardboard, fold it to double the thickness, punch holes through it, and use some thin cord to tie it through the hole in the spike. This is low-tech and works if I lose my protector while traveling, which is what always happens. No matter where I am, it's always pretty easy to get some cardboard.

For the adze, duct tape works. In fact, I know people who climb with duct tape over the adze, on the theory that it will keep them from getting cut accidentally by the edge. You don't need the adze for self-arrest. If you need to cut hard ice or something, you can take off the duct tape (or the act of cutting might just take it off). The duct tape method also works for me when traveling, since I carry a small amount of duct tape anyway for use in taping toes, repairing ponchos, etc.

posted about 10 years ago

CC BY-SA 3.0

Ben Crowell‭

751 reputation 42 185 81 0

I use an empty prescription medication plastic bottle form CVS or Wallgreens. If it's a little bit loose, I can secure it with a duct tape.

posted over 7 years ago

CC BY-SA 3.0

user13854‭

1 reputation 0 1 0 0

What came to my mind when I read WedaPashi's answer about bicycle handles was the use of old bicycle tubes to build some sheath. The rubber of the tube is flexible but it's not too easy to perforate it, therefore you can build your sheath rather close-fitting. Also you can glue it easily with bicycle patch glue.

posted about 10 years ago

CC BY-SA 3.0

Benedikt Bauer‭

181 reputation 4 67 21 0

I use pneumatic hosing, something like this:

http://www.mcmaster.com/#standard-plastic-and-rubber-tubing/=uowues

It's super cheap (runs under a dollar/foot and a foot is more than you will need) and you can buy as short of a section you want at most hardware stores.

posted about 10 years ago

CC BY-SA 3.0

jake‭

1 reputation 0 1 0 0