Use of gore-tex for a DIY Double-layer hammock

−0

I'm planning to sew my own double-layer hammock. I found a simple pattern here: http://diygearsupply.com/diy-guides/hammock-guide/

I was thinking about modifying it a bit, to have the bottom layer made of Gore-Tex fabric. This adds some weight to the product, but also adds some layer of waterproof protection from the bottom (so maybe I could use it on the ground, where there are no trees around?).

I'm not sure how would the gore-tex behave when under the mechanical stress too. Any thoughts?

diy gore-tex hammock

posted almost 11 years ago

CC BY-SA 3.0

kender‭

1 reputation 2 0 0 0

Raw

Markdown

History

is a duplicate

This question has been asked before and has already been answered. It should be marked as a duplicate.

Please enter the URL of the proposed duplicate in the details field below.

not constructive

This question cannot be answered in a way that is helpful to anyone. It's not possible to learn something from possible answers, except for the solution for the specific problem of the asker.

This post was sourced from https://outdoors.stackexchange.com/q/5306. It is licensed under CC BY-SA 3.0.

0 comment threads

2 answers

Score Active Age

−0

Perhaps not surprisingly, there's not a lot of information floating around about what happens when you subject gore-tex to this kind of stress. Gore-tex is a porous material, so stretching it might yield unexpected results. Worst case scenario, you set your gore-tex hammock on wet ground and the water slowly seeps through. Then again, if the pores are typically 20,000 times smaller than a water droplet, theoretically if you stretch those pores they'll still be thousands of times smaller than a water droplet. You may need to try it and find out.

Also, consider that you might not want to focus on waterproofing the bottom of your hammock in the first place. If you waterproof the bottom, and find yourself in a wet climate, you're more likely to be trapping moisture in than keeping it out.

http://en.wikipedia.org/wiki/Gore-Tex

posted almost 11 years ago

CC BY-SA 3.0

Scott Hillson‭

101 reputation 0 33 10 0

Copy Link

Raw

Markdown

History

This post was sourced from https://outdoors.stackexchange.com/a/5310. It is licensed under CC BY-SA 3.0.

0 comment threads

−0

If you want waterproofing available to put under you, I would just bring along a 2 mil thickness of plastic for use as a ground sheet. This will be much lighter and cheaper than the same square-footage of goretex. That thickness will tend to get torn on a long trip, so you may want to bring a little duct tape for use in patching it.

posted almost 11 years ago

CC BY-SA 3.0