Why should the angle in a rope attached to two anchors be 60 degrees or less?

The diagram shows three situations that are easy to understand without knowing a lot of math or physics.

In the first example, the angle between the anchor strands is zero. Both anchors pull straight up on the biner, and each supports 50% of the load.

In the second example, all three angles are 120 degrees. The situation is totally symmetrical, so all three forces are equal in strength. Each anchor strand has to be able to support 100% of the load. For example, if the climber is hanging from the rope (a static load), and weighs 100 pounds, then each anchor strand will also be subject to 100 pounds of stress. This is obviously not that great a situation, and each anchor is just as likely to fail as if you had simply hung the climber off of that anchor alone. However, the anchor is redundant, so this is still better than a single anchor.

The third example shows a hypothetical situation where the angle at the top opens up to 180 degrees. This isn't actually physically possible. Each anchor strand is only applying a horizontal force to the biner. There is no upward force on the biner that could cancel the downward force from the climber's strand. No matter how tight you were to pull the two anchor strands, they would never flatten out to 180 degrees. As the angle gets closer and closer to 180 degrees, the strain approaches infinity, and you're guaranteed that something in the system will fail. Maybe the rope will snap, or maybe the biner will break, or maybe one of the anchors will pull out.

There is nothing magic about 60 degrees. As the angle increases, the stress on each anchor increases. An angle of 50 degrees could be too much, if your anchors were poor and you needed to hold a big dynamic load. An angle of 90 degrees could be perfectly OK, if the anchors were good and they just needed to hold a small static load. There could be a situation where I just had no choice but to do an arrangement like the 120-degree example, because it just wasn't physically possible to set up with a smaller angle. (Maybe something's in the way, or there's not enough rope, or the smaller angle would require the biner to be so low that I couldn't safely reach it, or the smaller angle would send anchor strands over a sharp knife-edge of rock.) I would still prefer such a setup to a non-redundant anchor.

posted over 10 years ago

CC BY-SA 3.0

Ben Crowell‭

751 reputation 42 185 81 0

This is due to the load that is passed to each anchor. You might think that (for example) two anchors will receive 50% load each during a fall or simply when the climber weights the rope. But actually the amount of load an anchor receives depends on the angle of the rope that this is attached to.

Typically a belay with two anchor points forms a triangle

Anchor   Anchor
 *      *
  *    *
   *  *
    *
  Attachment
    point

The angle (at the attachment point) of this triangle dictates the amount of load that is passed to each anchor. If the angle is 60 degrees of less each anchor point receives 58% or the load placed on the attachment point. This is generally regarded as a safe amount.

As the angle increases beyond 60 degrees:

Anchor                      Anchor
 *                           *
    *                      *
       *                 *
          *           *
             *     *
                *
           Attachment
              point

The load placed on each anchor also increases. At 90 degrees the load is 71%. At 120 Degrees it's 100%!!

So you should always keep the angle between anchors under 60 degrees.

posted over 10 years ago

CC BY-SA 3.0

System‭

2019 reputation 180 537 246 0