What is the easiest way to remove creosote from pots and pans?

Acetone or nail varnish remover dissolves the tars. It's possible that kerosine or gasoline could work but acetone worked.

posted over 4 years ago

CC BY-SA 4.0

Karl Rosenqvist‭

11 reputation 0 1 1 0

Heat up the creosote covered pan. This softens it. Then pour some denatured alcohol on it and scrub it off. I used a scotch bright pad to scrub with the alcohol, and then wiped the now liquid creosote off with a rag. It will make the rag black and perhaps ruined but it will come off slick and easy. Do this in a well-ventilated area!

posted over 5 years ago

CC BY-SA 4.0

Ben Smith‭

1 reputation 0 1 0 0

According to this page on DollarStretcher:

Simply apply ketchup (any cheap brand) to the pan and scrub with a steel wool pad. Sometimes it takes a little elbow grease, but it works great! The acidity of the ketchup works wonders and steel wool is a great shiner. I've also used this technique on brass and chrome with great results.

(However, this is just a general dishwashing tip, rather than a specific technique for creosote.)

posted over 8 years ago

CC BY-SA 3.0

RV Park‭

31 reputation 0 12 3 0

I haven't tried this on woodsmoke creosote, but in general I've found that dishwasher powder or tablets do a much better job on organic gunk than standard dish soap. I would try dissolving a hefty amount (maybe half a cup) of dishwasher detergent in a sinkful of hot water and leaving the pots in it overnight before scrubbing. You'll probably still need the steel wool but you might cut down the scrubbing time a bit.

Safety note: dishwasher detergent is pretty caustic stuff. Make sure to wear thick rubber gloves when working with it.

posted about 8 years ago

CC BY-SA 3.0

Pont‭

91 reputation 1 26 9 0

Unless the black stains bother you for visual reasons, let them be. Wash the pan off with normal dishwashing methods. This will take care of the stickyness and most contamination from pan to clothes/fingers etc and having a black layer on your pan does not harm its performance. In fact, where I am from, sporting a shiny clean kettle will get you a few scornful laughs, and people will complain about the food / coffee not tasting as it should =P

posted over 5 years ago

CC BY-SA 4.0

Stian Yttervik‭

71 reputation 0 19 7 0

Unfortunately this advice may a bit late for you now, but if you cover the outside of the pots in washing-up liquid before putting them on the fire/wood burner and clean it after use. The washing-up liquid should stop the soot sticking and it should wipe of fairly easily.

This approach is best if you are at a fixed campsite where you can easily wash your pots after use and the extra washing liquid is not too much of an issue. If you are backpacking it means you have to carry a large amount of washing liquid and/or carry sticky washing liquid covered pots neither of which are great ideas.

If you've already got your pots in a mess your options are limited. You'll probably need to do a lot of scrubbing, like you are. If you haven't already soaking your pots in soapy water overnight may help but I doubt it will solve the problem entirely.

posted over 8 years ago

CC BY-SA 3.0

nivag‭

226 reputation 8 71 23 0