Define dirty. The question says potable. The stuff that will hurt you requires very fine filtration that I don't think is feasible using natural elements. Filters for protozoan cysts and bacteria typically filter to 0.2 microns

Yes you can filter larger particulate matter (e.g. dirt) but that is not (typically) the dangerous stuff.

Is Water Treatment Even Necessary?
Q: Why do I need to treat water in wilderness areas?

A: Regardless of how pure water may look, any water source on the planet could be tainted with microscopic waterborne pathogens—disease-causing pests that, if ingested, could cause severe diarrhea, cramps, vomiting and fever.

Recent research, though, suggests that wilderness water at higher elevations is much cleaner than previously believed. Some experts argue that the blame for intestinal infections is more often traceable to preexisting conditions and lax sanitation, particularly unwashed hands.

Q: What's in wilderness water that can affect me?

A: Three groups of waterborne critters are most commonly linked to water-related illness:

• Protozoan cysts (Cryptosporidium parvum, Giardia lamblia). Tiny (1 to 300 microns; 1 micron = one-millionth of a meter).
• Bacteria (Escherichia coli, or E. coli, Salmonella, Campylobacter jejuni, Yersinia entercolitica, Leptospira interrogans and many others). Very tiny (0.1 to 10 microns).
• Viruses (hepatitis A, rotavirus, enterovirus, norovirus, Norwalk virus). Exceptionally tiny (0.005 to 0.1 micron). Viruses are rarely found in North American wilderness waters. Only purifiers (not filters) eliminate viruses.

posted over 7 years ago

CC BY-SA 3.0

paparazzo‭

441 reputation 1 155 46 0

Gravity Filters

Cone Filter

Much like Charlie's gravity filter in a bottle, this filter is essentially the same, only using a cone of tree bark in place of the bottle, and using extra filtration layers instead of a coffee filter or bit of cloth:

Tripod Filter

Using a shirt, or bag with a hole in the bottom, or whatever bits of material you can spare, you can set up a tripod filter as shown below:

^{Images: Pinterest, of all places...}

These filters appear to only be effective at cleaning the water of dirt and debris, boiling the water is still recommended for purifying the water and killing anything that might make it through your filter, though any poisons should be mostly absorbed by the charcoal.

What remains to be discovered is what could potentially be used in either of these systems to purify the water as much as possible without boiling.

Filtration Layers

The following are layers you can include in your filter, and what they accomplish:

• Grass: Filters out floaties, larger debris, and works as a permeable layer to support sand and charcoal.
• Pebbles: Remove larger grits like sticks, leaves, gravel, small stones, etc.
• Gravel: Permeable layer that packs well, good base layer for sand and charcoal, also filter larger particles.
• Sand: Filter out smaller grits, sand, etc.
• Ground Charcoal: Filter out finest particles, as well as some toxins/poisons (absorbed by carbon), will lose it's ability to absorb toxins with use.
• Twigs: Plug bottom of cone filter so other layers don't pour out bottom.

posted over 7 years ago

CC BY-SA 3.0

ShemSeger‭

1774 reputation 82 481 195 0

Here is what I have found for a very basic set up with a cheap water bottle. The water will be pored through the top through gravel, sand, charcoal and finally either a screen or another mechanism like a hankerchief to prevent the filtering substances from getting into the water.

Like this,

|    |
|GGGG|
|SSSS|
|CCCC|
 |00|

• | = Water bottle edge
• G = Gravel
• S = Sand
• C = Charcoal
• 0 = Screen or cloth

For more information I would suggest this instructable.

posted over 7 years ago

CC BY-SA 3.0

Charlie Brumbaugh‭

4244 reputation 382 566 570 43